Your LAPTOP POWER Cable

JerkStopper™ Installation Instructions
1. Install the appropriate PART B (Below) in an unused USB or RJ11 (Modem) or RJ45 (Network) port near the AC power connector plug on your computer. IMPORTANT NOTE: RJ11 & RJ45 are positive lock ports and are the preferred ports to use. USB ports are not positive lock. USB ports rely on friction and as such should be your last choice.
2. With the AC power cable connected to the computer, slide Part A over your AC power cable, leaving a little slack between the JerkStopper™ (part B) and the AC power plug on your computer.

3. Push Part A onto Part B engaging the locking teeth. Engage enough teeth to apply firm pressure on the cable to keep power cable from moving.

 

Made in the USA

Copyright © 2008, JerkStopper is a trademark of Damage Control Products LLC

Get a JerkStopper™ before it's too late!

LAST . . Stop worrying about accidentally jerking the AC power Cord.